Sony SDX-800V/R manual Restart the operation

	6.Command Specification						LOG SENSE
Code		Flag	Type	Flag Type	Recommended application client message		Probable cause
1Eh		Hardware A	O	C	The tape drive has a hardware fault:		The drive has a
					1.	Eject the tape or magazine.	hardware fault that
					2.	Reset the drive.	requires reset to
					3.	Restart the operation.	recover.
1Fh		Hardware B	M	C	The tape drive has a hardware fault:		The drive has a
					1.	Turn the tape drive off and then on again.	hardware fault which is
					2.	Restart the operation.	not read/write related or
					3.	If the problem persists, call the tape drive	requires a power cycle
					supplier helpline.		to recover.
					Check the tape drive user’s manual for device
					specific instructions on turning the device power
					on and off.
20h		Interface	O	W	The tape drive has a problem with the host		The drive has identified
					interface:		an interfacing fault
					1.	Check the cables and cable connections.
					2.	Restart the operation.
21h		Eject Media	O	C	The operation has failed:		Error recovery action
					1.	Eject the tape or magazine.
					2.	Insert the tape or magazine again.
					3.	Restart the operation.
22h		Download	O	W	The firmware download has failed because you		Firmware download
		Fail			have tried to use the incorrect firmware for this		failed
					tape drive.
					Obtain the correct firmware and try again.
23h		Drive	O	W	Environmental conditions inside the tape drive		Drive humidity limits
		Humidity			are outside the specified humidity range		exceeded
24h		Drive	O	W	Environmental conditions inside the tape drive		Drive temperature limits
		Temperature			are outside the specified temperature range		exceeded
25h		Drive Voltage	O	W	The voltage supply to the tape drive is outside the		Drive voltage limits
					specified range		exceeded
26h		Predictive	O	C	A hardware failure of the tape drive is predicted.		Predictive failure of
		Failure			Call the tape drive supplier helpline.		drive hardware
27h		Diagnostics	O	W	The tape drive may have a fault. Check for		The drive may have had
		Required			availability of diagnostic information and run		a failure which may be
					extended diagnostics if applicable.		identified by stored
					Check the tape drive users manual for		diagnostic information
					instructions on running extended diagnostic tests		or by running extended
					and retrieving diagnostic data		diagnostics (e.g. Send
							Diagnostic)
28h		Loader	O	C	The changer mechanism is having difficulty		Loader mechanism is
		Hardware A			communicating with the tape drive:		having trouble
					1.	Turn the autoloader off then on.	communicating with the
					2.	Restart the operation.	tape drive
					3.	If problem persists, call the tape drive supplier
					helpline.
29h		Loader Stray	O	C	A tape has been left in the autoloader by a		Stray tape left in loader
		Tape			previous hardware fault:		after previous error
					1.	Insert an empty magazine to clear the fault.	recovery
					2.	If the fault does not clear, turn the autoloader
					off and then on again.
					3.	If the problem persists, call the tape drive
					supplier helpline.
2Ah		Loader	O	W	There is a problem with the autoloader		Loader mechanism has
		Hardware B			mechanism.		a hardware fault

6-22 SONY AIT-3Ex drive SDX-800V series Ver.1.1