Sony SDX-800V/R manual Load Unload Command Parameter Combinations, Hold Reten Load Action

LOAD/UNLOAD 6.Command Specification

When the drive receives the UNLOAD, the tape is rewound to BOM and ejected. The operator must reload the drive manually. If, however, the drive has previously received a PREVENT MEDIA REMOVAL (with prevent bit set) command, the tape is retained in the drive. A subsequent LOAD command will load and position the tape at BOP ZERO. If an UNLOAD was sent instead, the drive would return NOT READY and the tape would remain within the drive. In this case, the drive requires a PREVENT ALLOW MEDIA REMOVAL (with prevent bit clear) command before an UNLOAD will eject the tape.

Note: While the PREVENT MEDIA REMOVAL is in effect, the Front Panel EJECT button is completely disabled.

If the cassette is unloaded but has not been ejected from the drive because of moisture detection, then a subsequent UNLOAD will cause the tape to eject from the drive. All commands except INQUIRY, REQUEST SENSE and READ BLOCK LIMITS will return a CHECK CONDITION status with a HARDWARE ERROR sense key set. The tape may also be ejected via the Front Panel EJECT button.

If no cassette is in drive, both LOAD and UNLOAD will return a CHECK CONDITION status with NOT READY sense key set

The valid combinations of the last four fields are given in Table 6-4 below.

Table 6-4: LOAD UNLOAD Command Parameter Combinations

HOLD	RETEN	LOAD	ACTION
0	0	1 (Load)	Normal load to access the medium without a retention operation, positioned at BOP0. Logical
			Unit in READY state. Immed may be ZERO or 1b.
1	0	1 (Load)	Load to access MAM only. Logical Unit in NOT READY state. Immed may be ZERO or 1b. MAM
			Load Count is not incremented. Unit Attention Condition set for MEDIUM AUXILIARY MEMORY
			ACCESSIBLE.
0	1	1 (Load)	Normal load to access the medium after a retention operation, positioned at BOP0. Logical Unit
			in READY state. Immed may be ZERO or 1b.
1	1	1 (Load)	Invalid Combination. Command terminates with CHECK CONDITION Status.
			The sense key is set to ILLEGAL REQUEST and the additional sense code is set to
			INVALID FIELD IN CDB.
0	0	0	Normal Unload/Eject of cartridge. Logical Unit enter NOT READY state. Immed may be ZERO or
		(Unload)	1b.
1	0	0	Unload of cartridge, but MAM still accessible but cartridge is not ejected. Logical Unit enters
		(Unload)	NOT READY state. Immed may be ZERO or 1b. Unit Attention Condition set for MEDIUM
			AUXILIARY MEMORY ACCESSIBLE.
0	1	0	Normal Unload/Eject of cartridge after a retention operation. Logical Unit enters NOT READY
		(Unload)	state. Immed may be ZERO or 1b.
1	1	0	Unload of cartridge after retention operation, but MAM still accessible. Logical Unit enter NOT
		(Unload)	READY state. Immed may be ZERO or 1b.

SONY AIT-3Ex drive SDX-800V series Ver.1.1 6-9