Sony SDX-800V/R manual MIC Read Error, Parameter Value Invalid, Saving Parameters not Supported

6.Command Specification REQUEST SENSE

04h			HARDWARE ERROR. Indicates that the drive detected a non-recoverable hardware
			failure not related to the tape (for example, controller failure, device failure, parity error,
			etc).While performing the command or during a self-test. If a previously acknowledged
			write-type operation was the cause, the valid bit is set. The error code in sense byte 16
			will indicate the specific problem. Refer to the error code table in the diagnostics clause
			for more information.
03		00	PERIPHERAL DEVICE WRITE FAULT - Drive electronics did not report successful
			completion to a Write operation.
	3F	01	MICROCODE HAS BEEN CHANGED – Illegal firmware code is reprogrammed.
44		00	INTERNAL TARGET FAILURE - Any unexpected internal error
			Conditions Indicating a Non-recoverable hardware failure. Refer to the field
			replaceable unit code field (sense byte 14) to determine which part of the drive is
			failing. Host should issue SEND DIAGNOSTICS with the self-test bit set to thoroughly
			test the drive. This sense information could also be returned after a send diagnostics
			command ends with a check condition status. Host should issue RECEIVE
			DIAGNOSTICS RESULTS for more details. Possible causes: buffer
			overrun/under-run, format violation, mechanical status time-out, internal data parity
			error, byte count mismatch, incorrect micro processor operation, unexpected SCSI
			protocol chip interrupt.
83		06	MIC READ ERROR
05h			ILLEGAL REQUEST. Indicates that there was an illegal parameter in the Command
			Descriptor Block or in the additional parameters supplied as data for some commands.
			If the target detects an invalid parameter in the command descriptor block, then it shall
			terminate the command without altering the medium. If the target detects an invalid
			parameter in the additional parameters supplied as data, then the target may have
			already altered the medium. This sense key may also indicate that an invalid
			IDENTIFY message was received.
	1A	00	PARAMETER LIST LENGTH ERROR - Indicates that the Parameter Length error in
			the Command Descriptor Block. Either the value does not fall on a Header, Page or
			Block descriptor boundary or the Parameter List Length is unexpectedly large.
20		00	INVALID COMMAND OPERATION CODE - Invalid or Unsupported command.

2400 INVALID FIELD IN CDB – Bits are set in one or more fields are not supported or are Reserved. Refer to the Field Pointer (Bytes 15-17) to identify the illegal bit or field.

2500 LOGICAL UNIT NOT SUPPORTED - The SDX-800V has an embedded SCSI controller with only one Logical Unit (LUN). The error indicates that the LUNTRN field in the Identify message was not ZERO.

2600 INVALID FIELD IN PARAMETER LIST - Test Number,

Configuration Number Header, or Field in the Parameter List was invalid or selected

Diagnostic test is not Host assessable.

2601 PARAMETER NOT SUPPORTED - Unsupported page requested. Refer to the Field Pointer (Bytes 15-17) to identify the illegal bit or field.

26	02	PARAMETER VALUE INVALID
2C	00	COMMAND SEQUENCE ERROR - Write Buffer command when tape is inserted and
		not at BOT.
39	00	SAVING PARAMETERS NOT SUPPORTED
3D	00	INVALID BITS IN IDENTIFY MESSAGE - Identify message was not 80h or C0h.

6-92 SONY AIT-3Ex drive SDX-800V series Ver.1.1