Delta Electronics ASDA-B Series manual ALE 43 Error communication response address

	Chapter 10 TroubleshootingASDA-B Series
ALE 43 : Error communication response address
Potential Cause	Checking Method	Corrective Actions
Receive the error		Check if the communication setting
	Check if the sending and receiving	is correct by using P8-05.
communication
	communication address are the same.	Verify the sending and receiving
response address
		data format.
ALE 44 : Error communication response command
Potential Cause	Checking Method	Corrective Actions
Respond the error		Verify the sending and receiving
communication	Respond the error Modbus command
		data format.
command.
ALE 45 : Communication parameter address error
Potential Cause	Checking Method	Corrective Actions
Respond the error	Check if the sending and receiving	Verify the sending and receiving
parameter address	communication code are the same.	data format.
ALE 46 : Communication parameter content error
Potential Cause	Checking Method	Corrective Actions
Respond error
parameter content	The data length of the content is error.	Verify the sending and receiving
when reading		data format.
parameter.
Respond error
parameter content	The data content is in error.	Verify the sending and receiving
when writing		data format.
parameter.
ALE 47 : Drive specification error
Potential Cause	Checking Method	Corrective Actions
Parameter SAVE	Use P8-13 to check if the specification stored in	1. Select the unused memory
	the memory block match the actual servo drive	block to save the parameter.
operation is in error.	specification when executing SAVE function
		2. Delete the memory block.
	(Save parameter settings to the Keypad).
	Use P8-13 to check if the specification stored in
Parameter WRITE	the memory block match the actual servo drive	Select the correct memory block.
operation is in error.	specification when executing WRITE function
	(Parameter settings written out to the Drive).
ALE 48 : Fast editing function error
Potential Cause	Checking Method	Corrective Actions
The function of static	The setting of P2-32 is incorrect.	Set P2-32 to Manual mode.
and auto-tuning is in
error.
The function of dynamic	Execution time out or the function is not	Please contact your distributor for
auto-tuning is in error.	executed completely.	assistance or contact with Delta.

Revision January 2009 10-11