Delta Electronics ASDA-B Series manual Yes

Chapter 4 Display and OperationASDA-B Series

WRITE Mode (Parameter settings written out from Keypad to the Drive)

1.When the power is applied to the AC servo drive, the digital keypad will enter into the monitor mode first.

2.In monitor mode, pressing WRITE key can switch to WRITE mode.

3.In WRITE mode, pressing WRITE key can execute the function the users select and save the new parameter settings.

4.In WRITE mode, pressing UP and DOWN key can write out the desired memory block that the users want to write out.

5.If the desired memory block has not been used, the LCD display will show the message “xxxxxxxx”. If the desired memory block has been used and there are parameters data saved in it, the LCD display will show the MCU version of the servo drive and the preset file name, such as “BL001-XX”. The last two words “XX” can be modified by the users and its range is within 0 ~ 9 or A ~Z. The users can select the words by using UP and DOWN keys and change the words by using SHIFT key.

6.In WRITE mode, pressing MODE key once can return to the previous display and finally exit the WRITE mode.

7.Only the parameters of the same version, the same inertia and the same model type of the servo drives can be written out. If the servo drive version stored in the keypad is different than the actual servo drive version, the users can make them the same via Delta Servo Drive PC software, ASDAB_SW.

Figure 4.4

WRITE

KPD WRITE yes?

WRITE

Press MODE key to return to previous display

WRITE

KPD WRITE 0.006

ROM00:BL003-00

KPD WRITE 0.006

ROM01:BL003-01

KPD WRITE 0.006

ROM24:BL003-24

MODE
	KPD WRITE 0.006
	ROM00:BL003-00?
ALARM 47	NO	WRITE
MODEL MATCH ERR
KPD WRITE 0.006	YES
ROM00:writing

Revision January 2009 4-5