Chapter 7 Servo Parameters|ASDA-B Series
7-18 Revision January, 2009
Keypad Parameters Control
Mode
Parameter Name Function Default Unit
P S T
P8-00★ KVER Keypad Firmware Version Factory
setting N/A { { {
P8-01 KFUN
Keypad Communication and Reset
Setting 1 N/A
{ { {
P8-05 KADR Communication Address Setting (Drive) 255 N/A { { {
P8-06 KBRT Transmission Speed (Keypad) 1 bps { { {
P8-07 KPTL Communication Protocol (Keypad) 0 N/A { { {
P8-08 KCMM Communication Selection (Keypad) 0 N/A { { {
P8-09 KTST Keypad Hardware Testing 0 N/A { { {
P8-10 KBLT LCD Backlight Display 0 N/A { { {
P8-11 KCLR Memory Block Clear 0 N/A { { {
P8-12 KRNO
Memory Block Position Number
(ROMx) 0 N/A
{ { {
P8-13★ KBL0 Status of Memory Block (ROMx) 0 N/A
{ { {
P8-14★ KBL1 Firmware Version of Memory Block
(ROMx) 0 N/A
{ { {
Explanation of symbols (marked after parameter)
(★) Read-only register.
(▲) Parameter cannot be set when Servo On (when the servo drive is enabled).
(●) Parameter is effective only after the servo drive is restarted (after switching power off and on).
(■) Parameter setting values are not retained when power is off.