Delta Electronics ASDA-B Series manual Setting value of P2-10 ~ P2-15 14 ~, SPD0 SPD1

Chapter 7 Servo ParametersASDA-B Series

Setting value of P2-10 ~ P2-15: 10

DI Name	DI Function Description	Trigger Method	Control
			Mode
	Speed limit enabled. When the drive is in torque mode and
SPDLM	SPDLM is activated, it indicates the speed limit command is	Level	T
	valid. The speed limit command source is internal parameter	Triggered
	or analog voltage.
Setting value of P2-10 ~ P2-15: 11
DI Name	DI Function Description	Trigger Method	Control
			Mode
	Electronic gear ratio (Numerator) selection. When users use
	two groups of electronic gear ratio, this DI signal can be	Level
GNUM0	used to switch the Numerator. When GNUM0 is not		P
	activated, it indicates the first Numerator (N1, see P1-44) is	Triggered
	used. When GNUM0 is activated, it indicates the second
	Numerator (N2, see P1-15) is used.
Setting value of P2-10 ~ P2-15: 12 ~ 13
DI Name	DI Function Description	Trigger Method	Control
			Mode
Reserved
Setting value of P2-10 ~ P2-15: 14 ~ 15

DI Name

SPD0

SPD1

DI Function Description

Speed command selection (1 ~ 4)

Speed command number: S1

CN1 DI signal		Content
	Command Source
SPD1	SPD0

			S	External	Voltage between
				analog
		Mode			V-REF and GND
0	0			command
			Sz	None	Speed command
					is 0 (zero)

Speed command number: S2

CN1 DI signal		Command Source	Content
SPD1	SPD0

Trigger Method	Control
	Mode

Range
+/-10 V
	Level	S
0	Triggered
Range

7-76 Revision January, 2009