Delta Electronics ASDA-B Series manual Status Display Save Setting Display

Chapter 4 Display and OperationASDA-B Series

4.2.3Status Display Save Setting Display

After the SET key is pressed, LED display will show the following display messages for approx. one second according to different status.

Display Message Description

The setting value is saved correctly.

		This parameter is read only. Write-protected. (cannot be changed)
		Invalid password or no password was input.
		The setting value is error or input reserve setting value.
		The servo module is enabled and this parameter cannot be
		changed.
Abort Setting Display
	Display Message	Description
		In parameter mode, pressing MODE key can abort parameter
		setting change and return to monitor mode. In parameter setting
		mode, pressing MODE key can return back to parameter mode.
		After returning back to parameter mode, pressing MODE key
		again can abort parameter setting change.
Fault Message Display
	Display Message	Description
		When the AC servo drive has a fault, LED display will display
		“ALEnn”. “ALE” indicates the alarm and “nn” indicates the drive
		fault code. The display range of alarm code “nn” is 1 to 48. For the
		list of drive fault code, please refer to parameter P0-01 or refer to
		Chapter 10 (Troubleshooting).
Polarity Setting Display
	Display Message	Description
		Positive value display. When entering into parameter setting
		mode, pressing UP or DOWN arrow key can increase or decrease
		the display value. SHIFT key is used to change the selected digit
		(The selected digit will blink).
		Negative value display. When the parameter setting is greater
		than five digits, after the display value is set, continuously press
		SHIFT key for six times and then the negative sign will show up to
		indicate a negative value.

4-28 Revision January 2009