Screen Burning
2.03.0Screen Burning
When the same image is reproduced for a long period (still image, telop, etc.), the image is burned into to screen. It may
be difficult to remove this image. Burning should be managed by making necessary changes in the video software,
projection method, system configuration etc.
This display has a function that reduces this kind of burning.
7Menu mode
1ENERGY SAVE setting: refer to sections 5.3.4, “Adjustment and setting in the Menu Mode 4) Energy Saving Setting” (pg. 119) and 5.3.7, “Adjustment and setting in the Menu Mode 12) Energy Saving Setting” (pg. 143) in the Technical Manual. The screen brightness is controlled according to the input signal and by the brightness of the room.
2ORBITER Setting: refer to section 5.3.4, “Adjustment and setting in the Menu Mode 5) Orbiter Setting” (pg. 121) and 5.3.7, “Adjustment and setting in the Menu Mode 13) Orbiter Setting” (pg. 145) in the Techicnal Manual. This function gradually and randomly moves the image position vertically and/or horizontally after a set amount of time. Or the edges of the images are restricted by setting soft focus in order to soften images edges.
7Integrator Mode
1SCREEN MASK Setting: refer to section 5.4.3, “Adjustment and setting in the Integrator Mode 9) SCREEN MASK Setting” (pg. 164) in the Technical Manual.
An inverse or full mask signal appears on the screen.
When a full mask is prepared beforehand, it becomes more difficult for the screen to become burned.
Using an inverse signal may be an emergency measure when the screen is burned from displaying a still image. However, completely removing the burn is not possible.
2SIDE MASK Setting: refer to section 5.4.3, “Adjustment and setting in the Integrator Mode 10) SIDE MASK Setting” (pg. 165) in the Technical Manual.
This setting adjusts the method of displaying the SIDE MASK signal and adjusts the signal level of the SIDE MASK signal.
7Menu Mode and Integrator Mode
1PROGRAM TIMER Setting: refer to section 5.3.4, “Adjustment and setting in the Menu Mode 11) Program Timer Setting” (pg. 127) and 5.3.7, “Adjustment and setting in the Menu Mode 19) Program Timer Setting” (pg. 151), ”5.4.3, “Adjustment and setting in the Integrator Mode 8) Program Timer Setting” (pg. 163) in the Technical Manual. The display contents change at a predetermined time according to set conditions.
7Standard Functions (Settings cannot be changed)
1Auto Brightness Adjustment (still image detection)
When an image that has little or no motion, such as a photograph or computer screen, is displayed for a long period, the screen may appear dimmer. This feature is part of the
Note This function is not found in the menu thus the setting cannot be changed.
20
