Q-Logic 59226-00 B manual System, Zoning, Table A-3. Switch Configuration Defaults

A – Command Line Interface Reset Command

S

switch

Resets the switch without a power-on self test. This is the default. This reset disrupts traffic and does the following:

„Activates the pending firmware.

„Closes all management sessions.

„Clears the event log. To save the event log before resetting, refer to the “Set Log Command” on page A-51.

To reset the switch with a power-on self test, refer to the “Hardreset Command” on page A-19. To reset the switch without disrupting traffic, refer to the “Hotreset Command” on page A-22.

system

Resets the system configuration settings to the factory default values. Refer to Table A-8for system configuration default values.

NOTE: Because this keyword changes network parameters, the workstation could lose communication with the switch.

zoning

Clears the zoning database and deactivates the active zone set. The zoning configuration values (autosave, default visibility) remain unchanged.

Notes	The following tables specify the various factory default settings:
	Table A-3. Switch Configuration Defaults
	Parameter	Default
	Admin State	Online
	Broadcast Enabled	True
	InbandEnabled	True
	FDMIEnabled	True
	FDMIEntries	1000
	Domain ID	1 (0x Hex)
	Domain ID Lock	False
	Symbolic Name	SANbox
	R_A_TOV	10000
	E_D_TOV	2000

A-32 59226-00 B