A

A – Command Line Interface Set Config Command

Table A-9. Set Config Port Parameters (Continued)

Parameter

Description

 

 

IOStreamGuard

I/O Stream Guard. Enables or disables the suppression

 

of RSCN messages. IOStreamGuard can have the fol-

 

lowing values:

 

„ Enable – Suppresses the reception of RSCN mes-

 

sages from other ports for which IOStreamGuard is

 

enabled.

 

„ Disable – Allows free transmission and reception of

 

RSCN messages.

 

„ Auto – Suppresses the reception of RSCN mes-

 

sages under the following conditions: 1) The port is

 

connected to an initiator device with a QLogic HBA,

 

2) The DeviceScanEnable parameter is enabled.

 

Auto is the default.

PDISCPingEnable

Enables (True) or disables (False) the transmission of

 

ping messages from the switch to all devices on a loop

 

port. The default is True.

 

 

switch

Initiates an editing session in which to change switch configuration settings. The system displays each parameter one line at a time and prompts you for a value. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets. Table A-10describes the Set Config Switch parameters.

Table A-10. Set Config Switch Parameters

Parameter

Description

 

 

AdminState

Switch administrative state: online, offline, or diagnos-

 

tics. The default is Online.

BroadcastEnabled

Broadcast. Enables (True) or disables (False) forward-

 

ing of broadcast frames. The default is True.

InbandEnabled

Inband management. Enables (True) or disables

 

(False) the ability to manage the switch over an ISL.

 

The default is True.

FDMIEnabled

Fabric Device Monitoring Interface. Enables (True) or

 

disables (False) the monitoring of target and initiator

 

device information.

 

 

59226-00 B

A-43

Page 197
Image 197
Q-Logic 59226-00 B manual Table A-10. Set Config Switch Parameters