
A – Command Line Interface Set Config Command
S
Table A-9. Set Config Port Parameters (Continued)
Parameter | Description |
|
|
AutoPerfTuning | Automatic performance tuning for FL_Ports only. The |
| default is True. |
| If AutoPerfTuning is enabled (True) and the port is |
| an FL_Port, MFSEnable is automatically enabled. |
| LCFEnable and VIEnable are overridden to False. |
| If AutoPerfTuning is disabled (False), MFSEnable, |
| LCFEnable, and VIEnable retain their original val- |
| ues. |
LCFEnable | Link control frame preference routing. This parameter |
| appears only if AutoPerfTuning is False. Enables (True) |
| or disables (False) preferred routing of frames with |
| R_CTL = 1100 (Class 2 responses). The default is False. |
| Enabling LCFEnable will disable MFSEnable. |
MFSEnable | |
| appears only if AutoPerfTuning is False. Prevents (True) |
| or allows (False) the interleaving of frames in a |
| sequence. The default is False. Enabling MFSEnable |
| disables LCFEnable and VIEnable. |
VIEnable | Virtual Interface (VI) preference routing. This parameter |
| appears only if AutoPerfTuning is False. Enables (True) |
| or disables (False) VI preference routing. The default is |
| False. Enabling VIEnable will disable MFSEnable. |
MSEnable | Management server enable. Enables (True) or disables |
| (False) management server on this port. The default is |
| True. |
NoClose | Loop circuit closure prevention. Enables (True) or dis- |
| ables (False) the loop’s ability to remain in the open state |
| indefinitely. True reduces the amount of arbitration on a |
| loop when there is only one device on the loop. The |
| default is False. |
|
|
|