A – Command Line Interface Set Command
S
log [option]
Specifies the type of entries to be entered in the event log. Refer to the “Set Log Command” on page
pagebreak [state]
Specifies how much information is displayed on the screen at a time according to the value given by [state]. This keyword does not require an admin session. [state] can be one of the following:
on
Limits the display of information to 20 lines at a time. The page break functions affects the following commands: Alias (List, Members), Show (Alarm, Log), Zone (List, Members), Zoneset (List, Zones), Zoning (Active, List).
off
Allows continuous display of information without a break.
port [option]
Sets port state and speed for the specified port. The previous Set Config Port settings are restored after a switch reset or a reactivation of a switch configuration. Refer to the “Set Port Command” on page
setup [option]
Changes SNMP and system configuration settings. Refer to the “Set Setup Command” on page
switch [state]
Changes the administrative state for all ports on the switch to the state given by [state]. The previous Set Config Switch settings are restored after a switch reset or a reactivation of a switch configuration. [state] can be one of the following:
online
Places all ports online
offline
Places all ports offline.
diagnostics
Prepares all ports for testing.
|
