Q-Logic 59226-00 B manual Reset Command, Syntax reset, Keywords config configname

A

A – Command Line Interface Reset Command

Reset Command

Resets the switch configuration parameters. If you omit the keyword, the default is Reset Switch.

Authority Admin session

Syntax reset

config [config_name]

factory

port [port_number] snmp

switch (default) system zoning

Keywords config [config_name]

Resets the configuration given by [config_name] to the factory default values for switch, port, port threshold alarm, and zoning configuration. If [config_name] does not exist on the switch, a configuration with that name will be created. If you omit [config_name], the active configuration is reset. You must activate the configuration for the changes to take effect. Refer to Table A-3through Table A-6for switch, port, and port threshold alarm configuration default values.

factory

Resets switch configuration, port configuration, port threshold alarm configuration, zoning configuration, SNMP configuration, system configuration, and zoning to the factory default values. The switch configuration is activated automatically. Refer to Table A-3through Table A-8.

NOTE: Because this keyword changes network parameters, the workstation could lose communication with the switch and release the Admin session.

port [port_number]

Reinitializes the port given by [port_number]. Ports are numbered beginning with 0.

snmp

Resets the SNMP configuration settings to the factory default values. Refer to Table A-7for SNMP configuration default values.

59226-00 B A-31