Chapter 9 Configuring Radio Resource Management

Configuring Dynamic RRM

Using the GUI to Configure Dynamic RRM

Follow these steps to configure dynamic RRM parameters using the GUI.

Step 1 Access the Global Parameters > Auto RF page (see Figure 9-4).

Note Click Set to Factory Default at the bottom of the page if you want to return all of the controller’s RRM parameters to their factory default values.

Step 2 Table 9-1lists and describes the configurable RRM parameters. Follow the instructions in the table to make any desired changes.

Table 9-1 RRM Parameters

Parameter

Description

 

 

RF Group

Group Mode

Determines whether the controller participates in an RF group.

Options: Enabled or Disabled

Default: Enabled

Group Mode

Description

 

 

Enabled

The controller automatically forms an RF group with

 

other controllers. The group dynamically elects a leader

 

to optimize RRM parameter settings for the group.

 

 

Disabled

The controller does not participate in automatic RF

 

grouping. Rather, it optimizes its own access point

 

parameters.

 

 

Note Cisco recommends that controllers participate in automatic RF grouping. However, you can disable this feature if necessary by unchecking the check box. Note also, however, that you override dynamic RRM settings without disabling automatic RF group participation. See the “Overriding Dynamic RRM” section on page 9-23for instructions.

Cisco Wireless LAN Controller Configuration Guide

9-16

OL-8335-02

 

 

Page 172
Image 172
Cisco Systems 3.2 manual Using the GUI to Configure Dynamic RRM, RF Group, Default Enabled