Cisco Systems 3.2 manual Using Client Reason and Status Codes in Trap Logs, Client Reason Codes

Appendix D System Messages and Access Point LED Patterns

Using Client Reason and Status Codes in Trap Logs

Table D-1	System Messages and Descriptions (continued)
Error Message		Description
SENSED_TEMPERATURE_LOW		Check room temperature and/or other reasons for
		low temperature.
TEMPERATURE_SENSOR_FAILURE		Replace temperature sensor ASAP.
TEMPERATURE_SENSOR_CLEAR		Temperature sensor is operational.
POE_CONTROLLER_FAILURE		Check ports — possible serious failure detected.
MAX_ROGUE_COUNT_EXCEEDED		The current number of active rogue access points
		has exceeded system threshold.
SWITCH_UP		Controller is responding to SNMP polls.
SWITCH_DOWN		Controller is not responding to SNMP polls, check
		controller and SNMP settings.
RADIUS_SERVERS_FAILED		Check network connectivity between RADIUS
		and the controller.
CONFIG_SAVED		Running configuration has been saved to flash -
		will be active after reboot.
MULTIPLE_USERS		Another user with the same username has logged
		in.
FAN_FAILURE		Monitor Cisco Wireless LAN Controller
		temperature to avoid overheating.
POWER_SUPPLY_CHANGE		Check for power-supply malfunction.
COLD_START		Cisco Wireless LAN Controller may have been
		rebooted.
WARM_START		Cisco Wireless LAN Controller may have been
		rebooted.

Using Client Reason and Status Codes in Trap Logs

The WCS Clients > Detail page lists the reason and status codes that you are likely to encounter when reviewing the trap logs. Table D-2lists client reason codes and descriptions. Table y lists client status codes and descriptions.

Client Reason Codes

This table lists client reason codes.

			Table D-2	Client Reason Code Descriptions and Meanings
			Client
			Reason
			Code	Description	Meaning
0				noReasonCode	Normal operation.
1				unspecifiedReason	Client associated but no longer authorized.
		Cisco Wireless LAN Controller Configuration Guide
	D-4				OL-8335-02