Chapter 10 Configuring Mobility Groups

Configuring Mobility Groups

This page shows the mobility group name in the Default Mobility Group field and lists the MAC address and IP address of each controller that is currently a member of the mobility group. The first entry is the local controller, which cannot be deleted.

Note Click Remove if you want to delete any of the remote controllers from the mobility group.

Step 2 Perform one of the following to add controllers to a mobility group:

If you are adding only one controller or want to individually add multiple controllers, click New and go to Step 3.

If you are adding multiple controllers and want to add them in bulk, click EditAll and go to Step 4.

Note The EditAll option enables you to enter the MAC and IP addresses of all the current mobility group members and then copy and paste all the entries from one controller to the other controllers in the mobility group.

Step 3 The Mobility Group Member > New page appears (see Figure 10-7).

Figure 10-7 Mobility Group Member > New Page

Follow these steps to add a controller to the mobility group:

a.In the Member IP Address field, enter the management interface IP address of the controller to be added.

b.In the Member MAC Address field, enter the MAC address of the controller to be added.

c.In the Group Name field, enter the name of the mobility group.

Note The mobility group name is case sensitive.

d.Click Save Configuration to save your changes. The new controller is added to the list of mobility group members on the Static Mobility Group Members page.

Cisco Wireless LAN Controller Configuration Guide

 

OL-8335-02

10-9

 

 

 

Page 193
Image 193
Cisco Systems 3.2 manual 10-9, Mobility Group Member New