Chapter 10 Configuring Mobility Groups

Configuring Auto-Anchor Mobility

Using the CLI to Configure Auto-Anchor Mobility

Use these commands to configure auto-anchor mobility using the CLI.

1.Enter config wlan disable wlan-idto disable the WLAN for which you are configuring anchor controllers.

2.To create a new mobility anchor for the WLAN, enter one of these commands:

config mobility group anchor add wlan-id anchor-controller-ip-address

config wlan mobility anchor add wlan-id anchor-controller-ip-address

Note The wlan-idmust exist and be disabled, and the anchor-controller-ip-addressmust be a member of the default mobility group.

Note Auto-anchor mobility is enabled for the WLAN when you configure the first anchor controller.

3.To delete a mobility anchor for the WLAN, enter one of these commands:

config mobility group anchor delete wlan-idanchor-controller-ip-address

config wlan mobility anchor delete wlan-id anchor-controller-ip-address

Note The wlan-idmust exist and be disabled.

Note Deleting the last anchor disables the auto-anchor mobility feature and resumes normal mobility for new associations.

4.To see the list of controllers configured as mobility anchors for a specific WLAN, enter one of these commands:

show mobility anchor [wlan-id]

show wlan mobility anchor [wlan-id]

Note The wlan-idis optional and constrains the list to the anchors in a particular WLAN. To see all of the mobility anchors on your system, enter show mobility anchor.

 

Cisco Wireless LAN Controller Configuration Guide

10-14

OL-8335-02

Page 198
Image 198
Cisco Systems 3.2 manual Using the CLI to Configure Auto-Anchor Mobility, 10-14