Chapter 7 Controlling Lightweight Access Points

Autonomous Access Points Converted to Lightweight Mode

Disabling the Reset Button on Access Points Converted to Lightweight Mode

You can disable the reset button on access points converted to lightweight mode. The reset button is labeled MODE on the outside of the access point.

Use this command to disable or enable the reset button on one or all converted access points associated to a controller:

config ap reset-button {enable disable} {ap-nameall}

The reset button on converted access points is enabled by default.

Configuring a Static IP Address on an Access Point Converted to Lightweight Mode

After an access point converted to lightweight mode associates to a controller, enter this command to configure a static IP address on the access point:

config ap static-ip enable ap-name ip-address mask gateway

Cisco Wireless LAN Controller Configuration Guide

 

OL-8335-02

7-13

 

 

 

Page 149
Image 149
Cisco Systems 3.2 manual Config ap reset-button enable disable ap-nameall