A
A – Command Line Interface Set Setup Command
Table A-14. System Configuration Settings (Continued)
Entry | Description |
|
|
Eth0NetworkMask | Ethernet subnet mask address. |
Eth0GatewayAddress | Ethernet IP address gateway. |
AdminTimeout | Amount of time in minutes the switch waits before ter- |
| minating an idle Admin session. Zero (0) disables the |
| time out threshold. The default is 30, the maximum is |
| 1440. |
InactivityTimeout | Amount of time in minutes the switch waits before ter- |
| minating an idle Telnet command line interface ses- |
| sion. Zero (0) disables the time out threshold. The |
| default is 0, the maximum is 1440. |
LocalLogEnabled | Enables (True) or disables (False) the saving of log |
| information on the switch. The default is True. |
RemoteLogEnabled | Enables (True) or disables (False) the recording of |
| the switch event log on a remote host that supports |
| the syslog protocol. The default is False. |
RemoteLogHostAddress | The IP address of the host that will receive the switch |
| event log information if remote logging is enabled. |
| The default is 10.0.0.254. |
NTPClientEnabled | Enables (True) or disables (False) the Network Time |
| Protocol (NTP) client on the switch. This client |
| enables the switch to synchronize its time with an |
| NTP server. This feature supports NTP version 4 and |
| is compatible with version 3. An Ethernet connection |
| to the server is required and you must first set an ini- |
| tial time and date on the switch. The synchronized |
| time becomes effective immediately. The default is |
| False. |
NTPServerAddress | The IP address of the NTP server from which the |
| NTP client acquires the time and date. The default is |
| 10.0.0.254. |
EmbeddedGUIEnabled | Enables (True) or disables (False) the SANsurfer |
| Switch Manager Web applet. Changing this parame- |
| ter to False while the applet is running will terminate |
| the applet. The default is True. |
|
|
|
