A – Command Line Interface Set Config Command

S

Table A-10. Set Config Switch Parameters (Continued)

Parameter

Description

 

 

FDMIEntries

The number of device entries to maintain in the FDMI

 

database. Enter a number from 0–1000. The default is

 

1000.

DefaultDomainID

Default domain ID. The default is 1.

DomainIDLock

Prevents (True) or allows (False) dynamic reassign-

 

ment of the domain ID. The default is False.

SymbolicName

Descriptive name for the switch. The name can be up

 

to 32 characters excluding #, semicolon (;), and

 

comma (,). The default is SANbox.

R_A_TOV

Resource Allocation Timeout Value. The number of

 

milliseconds the switch waits to allow two ports to allo-

 

cate enough resources to establish a link. The default

 

is 10000.

E_D_TOV

Error Detect Timeout Value. The number of millisec-

 

onds a port is to wait for errors to clear. The default is

 

2000.

PrincipalPriority

The priority used in the FC-SW-2 principal switch

 

selection algorithm. 1 is high, 255 is low. The default is

 

254.

ConfigDescription

Switch configuration description. The configuration

 

description can be up to 32 characters excluding #,

 

semicolon (;), and comma (,). The default is

 

Config Default.

InteropMode

Propagates just the active zone set throughout the fab-

 

ric (Standard, FC-SW-2 compliant) or the entire zoning

 

database (Interop-1, non-compliant). The default is

 

Standard.

LegacyAddressFormat

Available only when the InteropMode parameter is

 

Interop-1, this parameter enables (True) or disables

 

(False) the use of legacy address formatting for inter-

 

operating with non-FC-SW-2 switches. The default is

 

False.

 

 

A-44

59226-00 B

Page 198
Image 198
Q-Logic 59226-00 B manual Resource Allocation Timeout Value. The number