
A
A – Command Line Interface Show Command
alarm [option]
Displays the alarm log and session display setting. If you omit [option], the command displays the last 200 alarm entries. The alarm log is cleared when the switch is reset or power cycled. [option] has the following value:
setting
Displays the status of the parameter that controls the display of alarms in the session output stream. This parameter is set using the Set Alarm command.
broadcast
Displays the broadcast tree information and all ports that are currently transmitting and receiving broadcast frames.
chassis
Displays chassis component status and temperature.
config [option]
Displays switch, port, and zoning configuration attributes. Refer to the “Show Config Command” on page
domains
Displays list of each domain and its worldwide name in the fabric.
donor
Displays list of current donor configuration for all ports.
fabric
Displays list of each domain, symbolic name, worldwide name, node IP address, and port IP address.
fdmi [port_wwn]
Displays detailed information about the device host bus adapter given by
[port_wwn]. If you omit [port_wwn], the command displays a summary of host bus adapter information for all attached devices in the fabric. Illegal characters in the display appear as question marks (?).
interface
Displays the status of the active network interfaces.
log [option]
Displays log entries. Refer to the “Show Log Command” on page
|