Black Box 5000 manual Configuration, Prom #

Multiserver 5000

Display	voice/fax signal. The indicator
	lights on the voice/fax module show
	the level (see Figure 13.5). When
	this test is initiated, the display will
	read [Active].
Terminate	Terminates all the tests initiated at
Test	this menu.

Once a test is initiated, an [Active] message is displayed on the LCD. All tests remain active until terminated with Terminate Test. The next time you cycle through the LCD Menus, an [Active] message is displayed, meaning the test was previously invoked and is still active. When a test is complete or is terminated, the LCD will display [Inactive].

For additional information on these tests, consult the MS1 Voice/Fax Card User’s Manual.

\INTEGRAL DEVICES

When this menu is selected, the screen will prompt for the channel number to be tested. If a CSU/DSU module is installed in the Multiserver, the following diagnostic options will be offerred:

Option	Description
Local	Verifies the integrity of data entered
Loopback	into the local ISU.
Digital	Verifies the data path of the system
Loopback	from a terminal at the remote unit,
	and verifies the data path from a
	local terminal up to the ISU module.
	This test requires operator
	intervention at the remote unit. The
	Multiservers at both ends of the link
	must be in the Remote Composite
	Loopback Test to perform this test
	(see above).
Test Pattern	Generates a test pattern within the
(TP)	ISU to verify the ability of the ISU
	and the DDS to transfer data in both
	directions. This requires operator
	intervention at the remote unit.

Local	Verifies the local ISU module by
Loopback	using a test pattern generated
with TP	within the ISU module.
Terminate	Terminates all the tests initiated at
Test	this menu.

Once a test is initiated, an [Active] message is displayed on the LCD. All tests remain active until terminated with Terminate Test. The next time you cycle through the LCD Menus, an [Active] message is displayed, meaning the test was previously invoked and is still active. When a test is complete or is terminated, the LCD will display [Inactive].

For additional information on these tests, consult the MS1 56K CSU/DSU Module User’s Manual.

13.7 Configuration

Currently the only option in this menu that can be accessed is Hardware Overview. This function is a display only of the hardware configuration.

Press the down arrow to read the PROM # and right/left arrows to display the module information. The display shows the following items in this order:

PROM #

Slot $: NMS Module (if installed)

Slot A: Module and Revision

Slot B: Module and Revision

Slot C: Module and Revision

Slot D: Module and Revision

Slot E: Module and Revision

174