Black Box 5000 manual Remove any blank panels

CHAPTER 5: Module Installation

Figure 5-8. Remove any blank panels.

cover. The delicate metallic finger stocks are located at the front and rear of the cover. They are needed to make contact with the bottom enclosure and to ensure compliance with FCC Part 15 or FTZ radiated emission standards.

5.5.3REMOVE BLANK BACK PANELS

Each blank back panel is supported by two retaining screws. To remove the panel, unscrew and remove the screws. Then pull off the panel.

Remove all blank back panels down to the top module board.

NUMBER 1

SPACER

Figure 5-9. Remove spacers.

45