Black Box 5000 manual 232

Multiserver 5000

Screen Display Messages

Message	Message Type	Explanation
ni TRANSMITTER RING	Event	A call is coming in on the transmitter side.
DETECT LINK ci
ni TX CONNECTION MADE	Event	A successful call was placed over the dial-lines
LINK # ci		from the modem’s TX dial line connection. This
		message is displayed by the call-originating modem.
<UNASSIGNED>	Dialog	•	Node, class, module location, or port is unknown
			in the network.
		•	Password for the class may be incorrect.
		•	If matrix switching is disabled, this message will
			display when matrix switching is attempted.
<UNAVAILABLE>	Dialog	Requested resource exists, but is not in service (not
		operational). Call inhibit may be off or DTR is off.
VOICE CHANNEL	Event	Voice/fax port c on node n has been put in a
[n/c] [condition]		busyout state. [Conditions] may be the
BUSY OUT		following:
		System		Where the link has experienced a sync
				loss, a force-disable command, or a
				force-disconnect command.
		Forced		Where the network operator has put the
				channel in a busyout condition via a
				forced-busy command.
VOICE CHANNEL [n/c]	Event	Termination of a busyout condition has
BUSYOUT CLEARED		occurred on voice/fax channel c.
VOICE CHANNEL [n/c]	Event	The current dBm level for voice/fax port
INPUT LEVEL: nn dBm		c on node n is nn (-25 to +1) dBm.
- [display] -		Note:		[Display] is a dynamic display
				which appears on the screen.
VOICE CHANNEL [n/c]	Diagnostic	Voice/fax port c on node n has started the
LOCAL LOOP TEST		diagnostic local loop test.
VOICE CHANNEL	Event	The voice/fax port has been reset and
[n/c] RESET		re-initialized to the current configuration.
VOICE CHANNEL [n/c]	Diagnostic	Voice/fax port c on node n has completed
SELF TEST FAIL		the internal diagnostic tests unsuccessfully.
VOICE CHANNEL [n/c]	Diagnostic	Voice/fax port c on node n has completed
SELF TEST PASS		the self-tests successfully.

232