|
| Appendix D: Messages |
| LCD Messages | |
Message | Message Type | Explanation |
|
|
|
ARE YOU SURE? | Info | A reset is requested. If the answer is yes, press the |
|
| EXEcute key to proceed with the reset. If the |
|
| answer is no, press ANY OTHER KEY except the |
|
| EXEcute key to terminate without a reset. |
ARE YOU SURE? | Info | You have attempted to reconfigure a node |
EXE FORCES A RESET |
| number and ID. This invokes a reset and this |
|
| message. Press EXE to accept the new config- |
|
| uration and invoke the reset. Press any other key to |
|
| abort. |
BATTERY LOW ni | Event or Alarm | The CMOS battery at node ni is low, and a power |
|
| loss could result in a cold start of the system. |
CHANNEL NOT | Info | The selected port is inoperative or the module |
AVAILABLE |
| location is empty. |
CHANNEL TYPE NOT | Info | The port configuration for the selected port |
APPLICABLE |
| does not apply for the function requested. |
|
| Example: You request a channel reset for a port |
|
| configured as a link. |
ni CMOS ERROR | Event or Alarm | The Multiserver software has detected a problem |
|
| writing to the Multiserver configuration area. |
|
| Contact your service representative. |
CONFIGURATION ERROR | Info | An attempt was made to change the modem |
NO ACTION TAKEN |
| configuration, and the change did not take effect. |
DIAL CONNECT MADE | Event or Alarm | The Automatic Dial Backup (ADB) option has |
LINK ci |
| completed the backup dial connection for link ci. |
INTEGRAL DEVICE BUSY | Info | The system is very busy and you have attempted |
|
| modem diagnostics or configuration. Usually a |
|
| second attempt will succeed. |
INTEGRAL DEVICE MODE | Info | You have attempted to execute a device |
INHIBITS SELECTION |
| function or option and the device is in a mode of |
|
| operation that temporarily inhibits the execution. |
235