|
|
| Appendix D: Messages |
|
| Screen Display Messages | |
| Message | Message Type | Explanation |
|
|
| |
RESET REQ’D | Info | You have changed the sync protocol and did not | |
|
|
| perform a reset. It is necessary to reset the node |
|
|
| before proceeding. |
ni | RING DETECTED LINK # ci | Event | The number dialed (TX or RX, primary or secon- |
|
|
| dary) is ringing. This message is displayed by the |
|
|
| call answering modem. |
ni | RX CONNECTION MADE | Event | A successful call was placed over the dial lines |
LINK # ci |
| from the modem’s RX | |
|
|
| message is displayed by the call answering modem. |
SIGNAL PROCESSOR FAIL | Event | The modem failed the | |
|
|
| dealer. |
SIGNAL PROCESSOR PASS | Event | ||
ni | SL TIME OUT ci | Info | Sync loss has occurred continuously for 40 |
|
|
| seconds. |
ni | SYNC ACQUIRE ci | Event | Synchronization has been achieved with the remote |
|
|
| Multiserver unit or feeder mux attached on link ci. |
SYNC CHANNEL | Diagnostic | Synchronous port c on node n has been | |
LOOPBACK n/c |
| placed into loopback mode. | |
SYNC CHANNEL n/c | Alarm | Synchronous port c on node n has lost its | |
STOPPED |
| output clock, or input end of frame is missing. | |
ni | SYNC LOSS LINK ci | Alarm | Synchronization has been lost with the remote |
|
|
| Multiserver unit or feeder mux on link ci. |
TEST CLEARED LINK # ci | Diagnostic | A modem test has been terminated. | |
THE CHANNEL MUST BE | Info | Appears when a channel type or protocol change | |
DISCONNECTED |
| is requested and the port is connected. | |
TIMEOUT | Info | The request is not accepted by the modem. | |
ni | TRANSMIT/RECEIVE | Event | A call is being transmitted or received. |
RING DETECT LINK ci |
|
| |
ni | TRANSMITTER BUSY | Event | The local transmitter detected a busy signal. |
LINK ci |
|
| |
ni | TRANSMITTER | Event | The ADB software is dialing the transmitter |
DIALING LINK ci |
| number for link ci. | |