Black Box 5000 manual Module-Location Switch Settings

CHAPTER 5: Module Installation

	SWITCH
1	GROUP
	S1
2
3
4

OPEN OPEN OPEN OPEN

FOR MODULE	FOR MODULE	FOR MODULE	FOR MODULE
LOCATION B	LOCATION C	LOCATION D	LOCATION E

Figure 5-2. Switch S1 and module location settings.

Up position = open = off

Down position = closed = on

5.2 Module-Location Switch Settings

Each expansion module has a module-location switch group S1 that informs the software of its location in the Multiserver unit (see Figure 5-2). There are two exceptions: the CCM, which is always in module location A, and the NMS module, which is always located below the CCM. The physical location of the switch is unique to each module.

Switch group S1 consists of four positions numbered 1 through 4. Before setting S1, first determine the location where the module is to be installed. Then, set the switches to match the intended module location. For example, if the

intended module location is C, set switch 2 on, and the other three off. To set a switch on, use a ballpoint pen or similar pointed tool and push the switch down.

NOTE: Switch group S1 settings for module locations B through E are different for each module location (see Figure 5-2). Be sure that each switch reflects the correct setting for the intended module location. Also, take care that only one switch is on (down) and that the remaining three switches are off (up).

41