Black Box 5000 manual Blank Back Panel, Disassembly Procedures

CHAPTER 5: Module Installation

BLANK PANEL

Figure 5-4. The back of a multiserver unit with a blank panel.

5.4 Blank Back Panel

The unit is delivered with blank back panels to eliminate an open area in the rear of the unit where there are no modules installed (Figure 5-4). Do not discard unused blank back panels; they may be needed later.

5.5 Disassembly Procedures

The disassembly of your Multiserver unit will require access to the sides and top of the unit to remove the cover, and to the rear to remove the back panels. This may be accomplished with the unit in its normal operating position provided there is sufficient clearance—about six inches above the unit and the length of a screwdriver on either side. If there is not a sufficient amount of access space, you will need to remove all external cables to move the unit to a work space.

Figure 5-5. Unplug the Multiserver before disassembly.

43