Black Box 5000 manual Diagnostics, Press the EXEcute key again and the Multiserver will reset

Press
Key	Resulting Display

Node name: [!240]

The node number appears in the brackets. (The number shown above in the brackets is the default node number.) The cursor will be in the farthest numeric position to the right. Configure the node number using the keypad as explained below:

If you choose a number that is too large (for example, 712), an Out of range message will display. Depress any key to continue. If the number you choose is already in use on the network, the following message will display:

Number already in use. Depress any key.

The node number appears in the brackets. (The number shown above in the brackets is the default node number.) The cursor will be in the farthest numeric position to the right.

Important

The alphanumeric sequence starts with a space, then 0 to 9, A to Z, and

Move cursor one column to the left

Do not use

Increment character by one (if key is held, the character will increment rapidly)

Move cursor one column to the right

EXE Accepts the new node name

an underscore (_).

Do not configure a space as part of the node name; if you do, this error message will appear:

Invalid name character/s.

CHAPTER 13: LCD/Keypad

The space can be used to delete existing characters in columns that will be blank. (For example, if the !240 node ID becomes NY, the last two columns must be blank.)

Configure the node number using the keypad as explained below:

If the name you choose is already in use on the network, the following message will appear:

Name already in use. Depress any key.

After configuring the new node name, press the EXEcute key. The following will display:

Are you sure? EXE forces a RESET.

Press the EXEcute key again and the Multiserver will reset.

Important

You must accept the LCD/Keypad reset. Do not reset from the Command Facility or your new node ID will be lost.

13.6 Diagnostics

The Diagnostic Menu offers diagnostic tests for the

following: System , Voice/Fax, and Integral Devices.

NOTE: When the desired test appears on the LCD, press the EXEcute key to activate the test.

SYSTEM

171