Black Box 5000 manual Reset Defaults, Key

6.4 Reset Defaults

Use one of the following methods to ensure that the Multiserver’s configurations are set to standard default values.

•Enter the Command Facility Main Menu to perform a cold start.

COMMAND FACILITY MAIN MENU [node id]

10 RESET

RESET [node id]

1 NODE

ENTER A “Y” TO CONFIRM

OR “N” TO ABORT: Y

PARAMETER RESTORATION

1 DEFAULT VALUES

CHAPTER 6: Getting Started

•Perform a cold start using the front-panel keypad. Refer to Figure 6-2.

Banner
Message ⇒	Menu Functions
	⇓
	Administration
	⇓
	System
	⇓
	Clear Latched
	Alarms	⇒ System Reset
		⇓
		Default
		Configurations
		⇓
		EXE, EXE
		(Press twice)
Key:
⇒	Press right arrow

Figure 6-2. Cold start using

the LCD/Keypad Menu.

•Jumper E1 is located on the CCM board near the front of the Multiserver (see Figure 4-9on page 40). Unplug the Multiserver and then remove the Commpak. Use a small pair of pliers and remove Jumper E1 for 15 minutes. All power will slowly drain from the CMOS during this time. The CMOS’s memory will be erased and it will revert to its factory-set defaults.

55