Black Box 5000 manual Switch S1 on the NMS Module

When you have entered a valid number and ID, the following message will appear:

**SELECT “Y” TO RESET SYSTEM WHEN NODE CHANGES MADE**

ENTER “Y” TO RESET OR “C” TO

CONTINUE: Y

Enter Y to store your changes and to reset the local node.

If you select C, you will be returned to the NODE ID CONFIGURATION Menu and your configuration will be placed in temporary storage. You can then continue to configure additional nodes. Press Y when all the Node IDs have been configured.

Caution

If you exit the Node ID Configuration Menu before pressing Y, your new configuration will be lost. The old Node ID(s) will remain intact.

To terminate and halt the reset process (and retain the previous node name and number), press N.

CHAPTER 6: Getting Started

LCD/KEYPAD CONFIGURATION

You can name the local node on the front-panel keypad. See the Local Node Number and ID discussion in Section 13.5 Administration for instructions on this procedure.

NMS SWITCH CONFIGURATION

The S1 switch bank on the NMS Module can be used to configure the local node’s name and ID. See the NMS Module User’s Manual for instructions on this procedure.

S1

1 2 3 4 5 6 7 8

Figure 6-2. Switch S1 on the NMS Module.

57