
Multiserver 5000
Table 9-3. Sync Channel Characteristics (continued)
Option | Protocol | Default | Description |
Number of | ASCII Bisync | 1 | Sets the number of leading pad characters to be |
Leading Pad | EBCDIC Bisync | 1 | transmitted at the start of the block. This is used |
Characters* | 1 | for a time delay | |
| RTS/CTS | 3 |
|
| 1 |
| |
Number of | ASCII Bisync | 1 | Sets the number of trailing pad characters to be |
Trailing Pad | EBCDIC Bisync | 1 | transmitted at the end of the block. External device |
Characters* | 1 | will have time to recognize the end of a block. | |
| RTS/CTS | 3 |
|
| 1 |
| |
Buffer | DLC | NONE | Used to regulate data transmission from a device |
Control | ASCII Bisync | NONE | attached to the port. The default setting (NONE) |
| EBCDIC Bisync | NONE | removes all buffer control. When this option is |
| NONE | configured to CTS, the Multiserver will delay the | |
| RTS/CTS | NONE | CTS signal up to 250 milliseconds for buffer control. |
| NONE |
| |
| MICOM DLC | NONE |
|
| MICOM Voice | NONE |
|
Encoding | DLC | NRZ | Depending upon attached device, select NRZ or |
|
|
| NRZI. |
Idle Fill | DLC | FLAG FILL | There are four Idle Fill options. Selection depends |
|
|
| upon attached equipment: |
|
|
| • Mark Fill sets an idle pattern of binary 1s between |
|
|
| DLC frames. Use this for IBM 3270 SDLC half- |
|
|
| duplex operation. |
|
|
| • Fall Fill sets the idle pattern of hexadecimal 7E |
|
|
| (flag) between DLC frames. |
|
|
| • Auto Fill and A128 Fill automatically adjust idle |
|
|
| between DLC frames to mark at the end of the |
|
|
| transmission, or flag when the transmission is not |
|
|
| finished. For IBM AS/400 5250 SDLC operation, set |
|
|
| to either Auto Fill for Modulo 8 or A128 Fill for |
|
|
| Modulo 128 frame sequencing. |
Clock Flow | DLC | ENABLE | When Clock Flow Control is enabled, the local |
Control | ASCII Bisync | ENABLE | Multiserver controls flow on the local port if the |
| EBCDIC Bisync | ENABLE | Channel Clocking Option has been set to |
| ENABLE | ||
| RTS/CTS | ENABLE | clock. If NONE is chosen, there is no local data flow |
| ENABLE | control. The data is discarded, and it is up to the | |
| MICOM DLC | ENABLE | remote Multiserver to issue a retransmit request. |
* Prompt only. No menu.
88