
12.4System Diagnostics in the Command Facility
The system administrator may perform all of the following diagnostics from the Command Facility. Some of the tests may also be performed at the LCD/Keypad. Section 13.6, Diagnostics, explains each of the diagnostic functions that can be performed with the LCD/Keypad.
The Diagnostic Menu of the Command Facility is accessed as option 7 from the Command Facility Main Menu.
COMMAND FACILITY MAIN MENU [node id]
7 DIAGNOSTICS
DIAGNOSTICS [node id]
1.REMOTE COMPOSITE LOOPBACK
2.LINK CHANNEL LOOPBACK
3.ASYNC CHANNEL OUTPUT
4.SYNC CHANNEL LOOPBACK
5.VOICE/FAX TESTS
6.INTEGRAL DEVICE TESTS
7.LED TEST
8.MEMORY DUMP
CR - ACCEPT ENTRY
M- MAIN MENU
ENTRY:
REMOTE COMPOSITE LOOPBACK
The Remote Composite Loopback tests the interconnect link between the local Multiserver and a remote Multiserver. When initiated, this test interrupts all user data and
CHAPTER 12: Diagnostics
When this option is selected, the following prompt will appear:
ENTER LINK CHANNEL # (^X TO ABORT):
Enter the link channel (port). Press <cr>. The test will initiate. You should get an alarm message:
[time] [node id] SYNC LOSS LINK [channel #]
This indicates that the link being tested has been disrupted. The link will remain disrupted until the test is terminated (see Section 12.2, Terminate Test).
During the test, the
NOTE:
LINK CHANNEL LOOPBACK
When this option is selected, the following menu appears:
LINK CHANNEL LOOPBACK
1.LOCAL ECHO
2.REMOTE ECHO
3.LOCAL FOX
4.REMOTE FOX
Enter the number of the test you wish to perform. Press <cr>. The following prompt appears:
159