
Multiserver 5000
Table 10-2. Switching Parameters
Option | Default | Description | |
1. | Connect Protocol | Dedicated | Selects the communication protocol used. The protocol must be |
|
|
| compatible with the attached device. There are three options: |
|
|
| Dedicated — This option is used for terminals or computer ports which |
|
|
| can operate on data activity only. This protocol must be used |
|
|
| driver data channels. |
|
|
| DTR (Data Terminal Ready) — This option is used for terminals or |
|
|
| acknowledge call requests. This allows computer ports to delay incoming |
|
|
| calls until ready. This option is also useful for |
|
|
| modems where DSR or CD is crosswired to DTR. |
|
|
| Note: Any |
|
|
| $CMD to enter the Command Facility. |
|
|
| Auto — This option is used with dialup modems and will emulate a dialup |
|
|
| modem to a computer port. |
|
|
| If DTR or Auto Connect Protocol is chosen, EIA Control must be enabled |
|
|
| (option 2 of the async Channel Features menu. See Section 9.3, |
|
|
| Asynchronous Channels, and Table |
|
|
| Features, for more information. |
2. | Unbalanced Rates | On | This option enables/disables connections of ports which have dissimilar |
|
|
| baud rates (different speeds). |
3. | Call Inhibit | No | If this option is configured to Yes, the port cannot make a connection |
|
|
| request. The port will only be a receiving port. |
4. | Receive Inhibit | No | If this option is configured to Yes, the port cannot receive a connection |
|
|
| request. The port can only initiate calls. It will only be a calling port. |
5. | Character Set | ASCII | Defines whether an ASCII or |
|
|
| ASCII is selected, either a Destination Node/Class (option 8 of this menu) |
|
|
| must be configured or Call Inhibit (option 3 of this menu) must be yes. Do |
|
|
| not configure a password for a |
|
|
| Note: If the data rate for the port is configured at |
|
|
| 50 or 75 bps, |
6. | Matrix Switching | Enable | The option enables/disables the ability of the channel to originate or |
|
|
| receive a matrix switching call connection. Matrix switching is making a |
|
|
| connection by specifying a node ID/channel number. |
Note: If matrix switching is disabled, you will not be able to connect to the Command Facility Main Menu via $CMD.
116