Black Box 5000 manual Review Data-Channel Configuration

9.5 Review Data-Channel Configuration

REVIEWING SYNC-CHANNEL CONFIGURATION

To review sync-data channels, enter the View Configuration menu.

COMMAND FACILITY MAIN MENU [node id]

1 VIEW CONFIGURATION

VIEW CONFIGURATION [node id]

2 SYNC CHANNELS

CHAPTER 9: Data-Channel Configuration

ENTER NODE-ID/CHANNEL# (OR RANGE OF CHANNELS)(^X TO ABORT):

At

this prompt, enter the node ID, a slash, and a sync channel or range of channels you wish to review. (Channel ranges should be in the form: starting channel, dash, ending channel. For example, channels B1 through B6 would be entered as B1- B6.) All sync channels in the range will be displayed. If there are non-sync channels in the range, they will not be displayed.

All of the sync characteristics are discussed in Section 9.2 and Table 9-3. Any characteristic that has dashes (--) is not configurable for that protocol.

[node id] SYNC CHANNELS CHARACTERISTICS
		DATA	CLOCKING		BLOCK SIZE		DTE	CAR	BUFF	FLOW	DSR
CH	PROTOCOL	RATE	TX	RX	TX	RX	DCE	MODE	CNTRL	CNTRL	CNTRL

---------------------------------------------------------------------------

A02	DLC	2400	INT	INT	512	512	DTE	CON	NONE	ENA	NORMAL
A03	RTS/CTS	2400	INT	INT	512	512	DTE	VAR	NONE	ENA	NORMAL
[node id] SYNC CHANNELS CHARACTERISTICS
		SYNC	LEAD	PAD	LEAD	TRAIL			IDLE	DATA
CH	PROTOCOL	CHAR	SYNCS	CHAR	PADS	PADS		ENCODE	FILL	INV	PRI

---------------------------------------------------------------------------

A02	DTR	-----	--	--	--	--	NRZ	FLAG	----	LOW
A03	RTS/CTS	FF FF	03	FF	03	03	------	---	----	LOW

ENTER CARRIAGE RETURN TO CONTINUE

103