Black Box 5000 manual 228

Multiserver 5000

Screen Display Messages

Message	Message Type	Explanation
LOCAL DIGITAL	Diagnostic	The RD signal is being internally looped to the
LOOP LINK # ci		TD signal and transmitted onto the VF line.
LOCAL DTE LOOP	Diagnostic	The TD signal is being internally looped to the
LINK # ci		RD signal.
LOCAL FOX	Diagnostic	The port is in a local fox loopback test.
ni LOCAL LINK RESTART ci	Event	Node ni on link ci has been restarted.
ni LOCAL SYSTEM RESET	Alarm	The local Multiserver unit has been reset.
LOCAL TEST, ECHO INPUT	Diagnostic	The port has been placed into a local echo loopback
		test.
LOCAL TX/RX TEST	Diagnostic	The TX test pattern generator and RX error
PATTERN LINK # ci		detector have both been activated.
LOCAL VF LOOP LINK	Diagnostic	The local receiver VF signal is being routed into the
		modem, looped out through the local transmitter,
		and amplified through a variable gain stage.
LOCAL 1004 HZ	Diagnostic	The local modem is transmitting a test tone
TONE LINK # ci		of 1004 Hz over the telephone line.
LOCKED PARAMETER	Event	This parameter is locked out by the hardware
		configuration.
LOGGING REPORT,	Event	Command Facility is not available because it is
TRY LATER		being used to send reports.
MODULE NOT OPERATIONAL	Info	LAN module is installed but not operational.
<NO ANSWER>	Dialog	Indicates that no answer was received from the
		async destination port. Causes include the
		following:
		• Remote port did not respond to connection
		protocol.
		• No response was received within the call
		timeout period from the remote Multiserver,
		although the ports are known by the local
		Multiserver.
		• Call inhibit is enabled (on).
		• DTR = low = OOS.
ni NO ANSWER LINK ci	Event	The calling process has discontinued due to the
		absence of an answer tone on a local dial line.

228