Epson 3300 manual PPPoE, Use for clients in LAN, Primary DNS Type the IP address for primary DNS

End IP	Assign the end IP address of the IP pool that DHCP sever can
	use for clients in LAN.
Primary DNS	Type the IP address for primary DNS.

When you finished the above required settings, please click Finish. A system reboot page will appear. Click Apply to activate the DHCP mode configuration.

2.2.4 PPPoE

This mode is used for most of DSL modem users. All local users can share one PPPoE connection to access the Internet. Your service provider will give you the user name, password, and authentication mode for PPPoE settings.

If your ISP provides you the PPPoE (Point-to-Point Protocol over Ethernet) connection, please select PPPoE for this router to get the following page. Enter the username and password provided by your ISP on the web page.

User Name	Assign a specific valid user name provided by the ISP.
Password	Assign a valid password provided by the ISP.
Authentication	Select PAP or CHAP protocol for PPP authentication. The
	default value is PAP.
Service Name	Assign a service name required from ISP service.

After setting up the WAN interface, the user can click Next to setup the LAN interface continuously.

18 Vigor3300 Series User’s Guide