MAC Address | Router Default- |
| Use the default Mac address stored originally in router. |
| User Definition- |
| Use a MAC address defined by the user. |
Downstream Rate | Assign the downstream rate for this WAN interface. The default |
| value is 102400 kbps (100 Megabit). This setting is very important |
| for Vigor3300 Series incoming buffer adjustment. If you use a DSL |
| subscriber service with a 2Mbps downstream, please set the |
| downstream rate setting with 2Mbps. |
Upstream Rate | Assign the transmission rate for this WAN interface. The default |
| value is 102400 kbps (100 Megabit). This setting is very important |
| for Vigor3300 Series outgoing buffer adjustment. If you use a DSL |
| subscriber service with a 256Kbps downstream, please set the |
| downstream rate setting with 256Kbps. |
Type | Select a connection type for this WAN interface. Currently, there is |
| only one setting offered for you to choose - Fast Ethernet. |
Physical Mode | Select connection speed mode for this WAN interface. There are |
| auto negotiation, full duplex, and half duplex of either 10M or |
| 100M speed options for the WAN Interface. |
IP Mode | Select an IP mode for this WAN interface. There are four available |
| modes for Internet access, Static, DHCP, PPPoE, and PPTP. On |
| this page you may configure the WAN interface to use Static (fixed |
| IP), DHCP (dynamic IP address), PPPoE or PPTP. Most of the |
| cable users will use the DHCP mode to get a globally reachable IP |
| address from the cable host system. |
14 | Vigor3300 Series User’s Guide |
