Epson 3300 manual 2 LAN, For LAN IP/DHCP

3.2.2 LAN

In the Network group, select LAN option. The following page for LAN IP/DHCP will be shown.

For LAN IP/DHCP

In the Vigor3300 Series router, there are some IP address settings for the LAN interface. The IP address/subnet mask is for private users or NAT users. The IP address of the default gateway on other local PCs should be set as the Vigor3300 Series’ server IP address. When the DSL connection between the DSL and the ISP has been established, each local PC can directly route to the Internet. The IP address/subnet mask can also be used to connect to other private users (PCs). On this page you will see the private IP address defined in RFC-1918. Usually we use the 192.168.1.0/24 subnet for the route.

IP Address	Type the IP address for LAN/DHCP.
Subnet Mask	Type the subnet mask for the LAN IP/DHCP.
Status	Click Enable the DHCP server; click Disable to close DHCP
	server; click Relay Agent to close DHCP sever and do the job
	of DHCP server. Corresponding settings for Relay Agent can be
	configured in the page of DHCP Relay Agent.
Start IP	Sets the starting IP address of the IP address pool for DHCP
	server.
End IP	Sets the ending IP address of the IP address pool for DHCP
	server.
Primary DNS	Sets the private IP address of the primary DNS.
44	Vigor3300 Series User’s Guide