Hitachi GR2000 Series manual Subject interface name set in the IP information or, Refer to Table

	Filtering/QoS Information
<InterfaceDescription:Name>	The subject interface name set in the IP information or the
	IP-address information is designated. (The IP information or
	IP-address information should have been set before inputting
	this command.) The RM Ethernet is not supported. For details,
	refer to Table 1-5.
Default:	No default is possible.
{inDescription:out}	Inbound/Outbound is designated. Either one or both of the
	Inbound/Outbound can be set simultaneously.
	in :Inbound (designation on the frame input side)
	out:Outbound (designation on the frame output side)
Default:	No default is possible.
[-disable]Description:	The flow control is nullified by each input/output interface.
Default:	No default is possible.
listDescription:<ListNo.>	The list numbers are designated.
Default:	Default is possible only for the case of indication. All the lists
	are indicated at default.
Range of value:	IPv6 filter list: 40001 to 60000 (decimal)

[listDescription:<ListNo.>-listSpecifies<listNothe.>]range of a list number. This parameter can be specified only when a blank list number is displayed.

		Default:	The range of the list number to be displayed corresponds to all
			list numbers.
		Range of value:	IPv4 filter list: 1 to 20000 (decimal)
			IPv6 filter list: 40001 to 60000 (decimal)
	freeDescription:		Displays the blank list number.
		Default:	Cannot be omitted when the blank list number is displayed.
		Description:	Displays the top blank list number in the specified range.
	min_Default:no		Cannot be omitted when the top list number of a blank list
			number is displayed.
	￿	Flow detecting condition parameter
Ver. 07-02		Description:	The high-order protocol numbers or protocol names are
	{ip<protocolNo.>tcpudpicmp6}
			designated. If all protocols are taken as the object, IP is
			designated.
GR2K-GA-0014			1-45