Hitachi GR2000 Series manual Definitions, Related Configura ion Object

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

Deleting SMTP server definitions.

Deleting desti ation e-mail address definitions.

4.	Conf rm fullydletethatreportthe SMTP server settings (host name or IP address, port
	Are yousure?(y/n):y	definitions.
	￿Deleting -mail
	(config)#
Related Configura ion Object
Pre hots(Hstdnautionss-resolver(DNSnameinformation)resolverinformation)
1.	It is necessary to have	GR2000 Product Support Service (PSS) contract in order
	to us this func ion. Contactstpour sales department for information regarding PSS
	ntracts. It is also necess ry to connect the device to a network environment
	that enables -mail transmissions via the Internet.
2.	It is possible to set maximum of 1 entry for local e-mail address, SMTP server
	and destination -mail address.email-from
3.	When using -mail reports, it is necessary to set the local e-mail address, SMTP
	s rver and des ination	-mail address. Set, change or delete the destination
	-mail ad ress after se ting the local e-mail address and SMTP server.
	number) coincide with the SMTP settings of the connection destination. The
	message is discarded if the connection with the destination SMTP server fails
	when sending an e-mail report.
5.	Confirm fully that the	-mail address settings coincide with the settings in the
	SMTP server definition. The message is discarded if the e-mail transmission fails.

6.This function is only usable with IPv4. Therefore, if a host name that only has an IPv6 address defined in the SMTP server by "hosts" (host name information) is specified, e-mail reports to the server destination is discarded.

7.Host name of this device must be predefined by dns_resolver hostname.

8.If this command is inputted in the cases where changes are made on the IP routing protocol information, the IP multicast protocol information, and the MPLS information, and the apply command is not being executed, the apply subcommand is executed before the command is executed, and the changed IP routing protocol information, IP multicast routing protocol information, and MPLS information are reflected to the operation.

9.Do not set the local e-mail address that is set in the device in any other device on the network. If it is set, it may not be possible to send e-mail messages depending on the SMTP server, etc.

10.When using e-mail messages and log e-mail simultaneously, do not set more than 1 entry for log e-mail destination address and 1 entry for SMTP server. If defined with more than 1 entry, e-mail transmissions may be delayed several minutes beyond the set time due to entry count and the load conditions of the SMTP server used for log e-mail and e-mail messages.

4-18	GR2K-GA-0014
	Ver. 07-02