Hitachi GR2000 Series manual Definition

	Configuration Error Messages
Table 5-7 IPv6 Multicast Router Control Information Error Messages (continued)
pim6: duplicate group prefix <IPv6 Group	The prefix of the specified rendezvous point candidate has already
Prefix> / <Prefixlen>	been defined.
	<IPv6 Group Prefix>: Specified IPv6 multicast group address
	<Prefixlen>: Specified prefix length
pim6: duplicate pim6 clause	pim6 definition is duplicated. Delete one definition.
pim6: duplicate sparse parameter	sparse definition is duplicated. Delete one definition.
pim6: global or site local address not assigned	Unless the device address is defined, there is no setting pim6. First
on router local address	set the device address.
pim6: group prefix(<IPv6 Group Prefix>) has a	The group address specified by the rendezvous point candidate of
narrow scope	IPv6 PIM-SM must have a wider scope than the link local address.
	Set the scope of the group address to 3 or more.
	<IPv6 Group Prefix>: Specified IPv6 multicast group address
pim6: interface <Interface Name> is already	The interface address is duplicate-defined in pim6 definition.
defined	Specify it so that the interface address is not duplicated.
	<Interface Name>: Specified interface name
pim6: interface <Interface Name> not found	The interface of the interface name specified in pim6 definition
	cannot be found Specify the interface by the defined interface name.
	<Interface Name>: Specified interface name
pim6: invalid IPv6 address: <IPv6 Address>	The format of the specified IPv6 address is invalid. Specify the
	address in a proper format.
	<Prefixlen>: Specified address
pim6: the number of active pim6 interfaces	The total number of enable-specified interface addresses in pim6
(<Num>) should be less than 32	definition exceeds the maximum allowable number of addresses.
	Specify so that the number of enable-specified interface addresses is
	less than 32.
	<Num>: Number of enable-defined interfaces in pim6 configuration
	definition
pim6:ssm is not defined	Though the "ssm-join" command has been defined, the "ssm"
	command has not been defined.
pim6:the number of PIM-SSM groups is set up	The number of group addresses of IPv6 PIM-SSM exceeds the
exceeding the maximum	allowable limit. The maximum number is 1.
pim6: the total number of group prefix should	The total number of IPv6 group addresses in a rendezvous point
not be greater than 128	candidate exceeds the maximum number of addresses. Set so that
	the total number of group addresses is within 128.
pim6: unsupported interface <Interface	The interface specified in pim6 definition cannot be set. Do not
Name> specified	specify the interfaces below because they are not supported in an
	IPv6 multicast.
	1. Interface in which IPv6 address cannot be defined
	2. Tunnel interface
	<Interface Name>: Specified interface name
<Command>: syntax error	Syntax error
	<Command>: Command name\

GR2K-GA-0014	5-63
Ver. 07-02