Hitachi GR2000 Series manual Flow filter IPv4, When all high order protocol is target

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

1.1.5flow filter (IPv4)

Input Form

Setting and changing the global information by each input/output interface.

Settingset]flowand changingforwardlterthe<InerfaeName>{out}[flow information.-disable]

[Flow[-Flowdetectactiondetecting[{--reppoiy-lccondition]inggrscpondiup-<DSCPdropt<pin]licyValue>--policy<ItrfaceGroup--Name>indx<No.Name>}]]<IPAddress>list<ListNo.>

1.When all high order protocol is target.

2.<prWhenprecedenceip<IPtheSourchighValu>}]><IPorder<Length>]Destination>protocol[vlan<VLANis other[{dscpthanID>]<DSCPTCP, UDP,Value>ICMPprecedenceand IGMP.

3.Whenuperlwer}otocolthe highNo<pec[{dscp.order Source>protocolValue>}]<IPis TCPDestinatio. ation>[{dscp<DSCP_Value>}]

4.Whentcpack]dscp<IPthe[syn]Source>Porthigh order <DSCPprotocolSourc>]is UDP<IP.prcedenceDesti<precedence[<PortDstination>]

5. When<udLength>]the<DCPhighValuorder protocolDestination>prcedis ICMPce. _Value>}][{upperlower}

6.[{upperiWhenDSCPmp<IPtheValue>lower}Surc><IPhighorderprcedprotocolnc<preis IGMPdenc[<I. CMPValue>}]Type>[<ICMP_Cod>]][{dscp

Noteprecedenceg1: Enter<pthecedoperationValue>}]designation afterG[flow detection][{dscpconditions]<DSCPValue>whensetting or changing both [flow detection conditions] and the operation designation below parameter action simultaneously.

	Note 2: If the parameters	the "flow detecting condition" and the operation
	designation are to be changed, input all the setting contents again.
	Changing only the operation designation.
1-26	set]-index<Nopolicy-forwardflowfiltergroup<policy.>-}]op<Interface--policyGroup-Name><InterfaceName>{in-replaceout}lit<IPAddress>d<List<DSCPNoValue>.-actionVer.07-02
		GR2K-GA-0014