Hitachi GR2000 Series manual Parameter

	Filtering/QoS Information
Parameter
<InterfaceDescription:name>	Specifies the subject interface name set in the ip information
	or ip-address information. (The ip information or the ip-address
	information should be set before inputting this command.) RM
	Ethenet and Tunnel interface are not supported. For details,
	refer to Table 1-5.
Default:	No default is possible.
{inDescription:out}	Specifies the Inbound/Outbound. Either one or both of the
	Inbound/Outbound can be set against one interface.
in:	Inbound (specification of the frame input side)
out:	Outbound (specification of the frame output side)
Default:	No default is possible.
[-disable]Description:	Nullifies the flow control by input/output interface.
Default:	Flow control is executed.
listDescription:<ListNo.>	Specifies the list number.
Default:	Default is possible only in the indicated case. All the lists are
	displayed at default.
Range of value:	1 to 20,000 (ten-decimals)

[listDescription:<ListNo.>-listSpecifies<listNothe.>]range of a list number. This parameter can be specified only when a blank list number is displayed.

Default:	The range of the list number being the object of indication will
	the number of all the lists totaling the IPv4QoS list and
	IPv6QoS list.
Range of value:	1-255 (decimal) are designated to <No>. (Ver. 05-01, Ver.
	06-00)
	1-1000000 (decimal) are designated to <No.>. (Ver. 06-01)
Description:	Displays the blank list number.
freeDefault:	Cannot be omitted when the blank list number is displayed.
Description:	Displays the top blank list number in the specified range.
min_Default:no	Cannot be omitted when the top list number of a blank list
	number is displayed.
GR2K-GA-0014	1-65
Ver. 07-02