Hitachi GR2000 Series manual Arp

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

Table 4-14 List of Default Values That Can Be Set Using IP Information and Default Values During Initial Installation

Information	Information Name	Initial Value
Group Name
IP interface	ARP cache table aging time	30 minutes
information
	Interface type (Valid only for ATM/	Broad-type
	Frame-Relay.)
	Proxy ARP response	No proxy ARP response is made.
	Encapsulation format of ARP request	ethernet
	frame (Hardware type)
	Maximum number of transmission retries	4 times
	in ARP request frame
	Transmission retry interval of ARP request	2 seconds
	frame
	Relay of IP packets with source route	IP packets with a source router option are
	option	relayed.
	ICMP redirect message transmission	Transmit
	switch
	ICMPv6 redirect message transmission	Transmit
	switch
	Direct broadcast relay switch	Not relayed.
	Subnet broadcast relay switch	Not relayed.
	Non-response option of ICMPv6 node	• The initial value responds.
	information query	ip_icmp6_nodeinfo_query
		• To set a non-response option, execute
		the following.
		ip_icmp6_nodeinfo_query_off
	rate limiting option (RFC2463)	• The transmission rate of an ICMPv6
		error is limited to 1 packet/
		<Microsecond> (maximum).
		• The initial value is enabled(500∝ s).
		• To disable this function, set the
		<Microsecond> value to "0".
		• The <Microsecond> value can be set
		up to 1000 in units of 0 to 10.
ARP	ARP hardware type	Ethernet
information
DHCP	Hops threshold value	4
information

4-52	GR2K-GA-0014
	Ver. 07-02