Hitachi GR2000 Series manual Or more interfaces on the same bridge are connected to, Same network

Range of value:

Default:

You can assign a cost parameter to calculate best path from each interface to the root bridge. This parameter determines which bridge interface offers a lower-cost path to the root bridge. This parameter is valid only for interfaces with Spanning Tree turned “on”.

1-65535

10

IPX/Bridge Information

-costDescription:<Cost>

-priorityDescription:<Priority>You can define the upper 8 bits of port ID (16 bits). Use port ID

	to decide which interface should do the Frame Relay when two
	or more interfaces on the same bridge are connected to the
	same network.
Default:	128
Range of value	0-255

-disableDescription:-enableYou can define whether the transition state of the relevant interface is active or not. With -disable, you can prohibit Frame Relay of the specified frame. This parameter is valid only for interfaces with bridge mode operational (-spt).

Default:-enable

-translationDescription:-translationYou can selectoffthe function to translate FDDI frame into the ether frame format when transmitting to WAN or ATM. This parameter is valid only when the specified interface is WAN or ATM. This parameter supports only the bridge, connected with the specified ether interface. Use it if you cannot recognize FDDI frame.

	The	of frame format described here is only for MAC
	header (regularized with IEEE802.1H), which does not support
	partitioning a frame (fragmentation) in the bridge.
	-translation_off indicates no translation; -translation indicates
		.
Default:	-	_off

Examples

1.Parameter configuration

To set the interface sk1 as a spanning-tree bridge interface:

Ver. 07-02

GR2K-GA-0014(config)#bridge-interfaceline1-spt-cost10-priority128-translation2-31