Hitachi GR2000 Series manual Bridge-interface, You can define the bridge interface configuration

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

2.2.2bridge-interface

You can define the bridge interface configuration.

Input Format

Defining

Modifying[set]<VCbrigedName>isabenotrans-int-lys<Peerationrface--nablespt{Name>-<Lineranslatin}][}]<Group-Name>costt<Cost>][offName><DLCI}]<T-Name>prority<Timeslot<Priority>]Name>}

Deleting[set][{<VCbri-prityri-translaionnoNam>dge--ystio-ity>]{-Name><Lineranslatin}][[{-<GroupName>diableoff}]<Cost]Name><DLCI-enableName>}]		Name>}
Displayingdelete<VCbNam>-in	Name>{<LineName><DLCIName>}

show bridge-interface [{

}]

Parameters

<Timeslot{<LineDescription:Name>Name>}<DLCISpecifyName>the<VCinterfaceName>name<Peer. YouName>must set<Groupthe IP Name>interface

before configuring bridge. The maximum number is up to 160 per system and 32 per RP. In case of Frame Relay, you cannot use <timeslot> <groupname>. In case of ISDN, you can use

and cannot use <Group Name>. In case of ATM,

you can use <VC and <Group Name> that are specified to IP interface.

Default:None (cannot be omitted)

{-Description:no-yes-sptYou}can define the bridge operation mode of the selected interface. Select one of the following.

:Bridge function does not operate.

yes:Bridge function operates, but spanning-tree protocol does not.

spt:Bridge function and spanning-tree protocol operate.

Default:no

2-30	GR2K-GA-0014
	Ver. 07-02