Hitachi GR2000 Series manual To delete inbound, Pre, Auti, Config#

Filtering/QoS Information

3. Changing parameters

To change IP frame condition group names from ip1 to ip3 in the interface named office1:

					showqoss-pofffce1					1
			qos-ipoffice1iniplistgroupip3;
					q	-p	ffce1-n		-iplistgroupip3
4.	(config)#q s-t map					ett ngs
		Displaying
		To d splay the setting ntents of the inte face named office1:
		q s-di cardshow-modeqos-pether1
5.		q sqos- p-list-ipoffice1-group						outiplistgroupip2;
		Deleting settings					-etpings ice1of he interface named office1:
		To delete inbound
					showqos-ipoffice1
Pre			qos-ipoffice1outiplistgroupip2;
		auti		deleteqos-ip					ce1-in
	(config)#							inip		ip3;
Related Commands
		q s
		q s-queue-list
		q s- nterface
		q s- p-list
		ip
		ip-address

Related Information
For the flow control, refernipthe GR2000 Applicationsip3;	Guide.

1. Figure 1-12 shows the effect of QoS configuration definition output priority

	setting in ATM line. The output priority setting is valid in group name that
	grouped VC tokyo1 and Inbound (frame input side) of VC name tokyo2, but
	invalid in Outbound (frame output side) because ATM line does not control
	sending control. When output priority is set to Inbound of Ethernet, WAN, or
	ATM line, the setting is invalid at sending by ATM line. For example, when output
	priority is set in Inbound of line name tokyo4, it is valid at outputting packet
	received from the target line to line name tyokyo3 (WAN line), but invalid at
	outputting to tokyo1 or tokyo2 (ATM line).
GR2K-GA-0014	1-203
Ver. 07-02