Hitachi GR2000 Series Shaper shaper transmission information, Case of output priority control

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

Related commands

qos qos-queue-list qos-interface qos-discard-mode bridge-interface

Precaution

If this command is inputted in the cases where changes are made on the IP routing protocol information, the IP multicast protocol information, and the MPLS information, and the apply command is not being executed, the apply subcommand is executed before the command is executed, and the changed IP routing protocol information, IP multicast routing protocol information, and MPLS information are reflected to the operation.

1.2.12shaper (shaper transmission information)

This sets shaper transmission information. Three types of queuing modes, outbound priority control, low latency queuing + weighted fair queuing (LLQ+3WFQ) and weighted fair queuing (4WFQ), are set in interfaces. It is possible to produce a maximum of 256 entries per RP.

Input Format

Settings[[peakset]shprioritytheaequeuingr{kbirat{-set/s>limitedmodedefaultMbit/s>M}]queueingserpriority<VLAN{SetingName>-set[<Length4>]]]]dfaltqueuingusermode}]priority_off}

1.In the case of output1>priority[<Length2>control:[<Lngth3>

2.In the case of low latency queuing + weighted fair queuing (LLQ+3WFQ):

3.In<Rate3>%[<Length3>]{llq+3wfq[<Length4>]10%the case20%<Rate1>%ofweighted3040%[<Length1>]fairqueuing50%<Rate2>%60%(4WFQ):2>%70%[<Length2>]80%90%100%}

Changing4wfqsettings:<Rate1>%[<Length1>]<Rate4>[<Length4>][<Length2>]

Setting[[peakset]sh[priority]the queuing{<kbirat-s_/s>limitedmodedefault<Mbit/s>M}]queueingserpriority<VLAN{SettingName>-setdfaltqueuingusermode}]priority_off}

1.In the case of output priority control:

2.In the case of low latency[<Length2>[<Length3>[<Length4>]]]]queuing + weighted fair queuing (LLQ+3WFQ):

1-212	GR2K-GA-0014
	Ver. 07-02